Auto Generated UID (For Official Use Only):
25-05-30451840251
O*NET Job Zone:
Job Zone 1
O*NET Job Code:
49-2091
Work Days Per Week:
Monday, Tuesday, Wednesday, Thursday, Friday
Work Hours Per Week:
40
Estimated Work Hours Per Day:
8
Hourly Work Schedule Per Day:
Monday to Friday from 7:30am to 4:30pm
Are Hours Per Day Flexible?:
No, hours are set.
Payment Frequency:
Weekly
Estimated Annual Salary (If value is 0, employer did not provide):
45572
Opening Date of Announcement:
05/30/2025
Closing Date of Announcement:
06/22/2025
Anticipated Start Date of Employment:
09/10/2025
Anticipated Closing Date of Employment:
09/09/2026
Number of Job Openings:
1
Job Location:
Guam
Job Location Address:
Naval Base, Camp Blaz NCTS, Andersen Base Guam
FLSA Covered?:
Yes
DOD or VEVRAA Related?:
Yes
Overtime Available?:
Yes, overtime rate calculated at 1.5x per hour
Payroll Deductions:
Federal Income Tax, Medicare Tax, Insurance, Other Payroll Withholdings
Job Qualification Requirements:
Minimum requirements: Experience: One (1) year as a Cement Mason;
Education: 12th grade
Additional Job Information: Benefits, Required Tools, Supplies, etc.:
Benefits: Roundtrip airfare for off-island hire; Board and lodging @ $150.00 per week; local transportation to/from jobsite. Employer/employee–paid commercial medical insurance provided. Employee may be eligible for paid vacation and sick leave if mandated by project contract.
Successful applicant must be able to obtain military base access and are required to take and pass a substance abuse test after hire. Off-island hires must complete a pre-arrival and post-arrival health screening prior to working on Guam.
Job Posting Type:
New
Visa Type:
Not Applicable
H-1A/H-2A/H-2B Related?:
H-2B
Staff Notes (For Official Use Only):
Confirmed 6/11/2025 JMU.
Install, service, or repair air conditioning systems and ductwork in residences or commercial establishments. Repair or replace defective equipment, components, or wiring. Reassemble and test equipment following repairs. Lay out and connect electrical wiring between controls and equipment. Join pipe or tubing to equipment. Install, connect, and adjust thermostats, humidistats and timers using hand tools.
